Publicité
ASSEMBLY
List of parts
Castors • Base • Mechanism • Armrests • Backrest • M8 pads •
Seat with mechanism • Headrest (for HD version only) • Pneumatic lift •
6 pcs. of M6x25 mm bolts • 3 pcs. of M8x20 mm bolts • 2 pcs. of M5x20 mm bolts
1.
4.
1.
Push the castors into the base of the chair.
2.
Insert the air jack into the hole of the chair base.
Screw on the armrests using two M6x25 screws and one M6x20 screw
3.
for each armrest. For both R1 armrests, M8 round washers should be used for
the two outer bolts.
4.
Screw the backrest to the mechanism which is already placed in the seat,
using three M8x20 screws and three M8 washers.
Set the seat with screwed-on backrest and armrests on the actuator, which
5.
is already fitted in the base with castors. Screw the headrest on using two
M5x20 screws.
2.
5.
EN
3.
EN
1
Publicité
