Télécharger Imprimer la page

Pulsar 510 DL 5.0 Manuel D'instructions page 2

Publicité

PROTECTION FEATURES
Over-voltage/short-circuit protection: When the cartridge resistance is lower than 0.8 Ω, the red light flashes
3 times and the system enters standby mode. The red light flashes 3 times to turn off the output.
CLEANING INSTRUCTIONS
Remove the bottom magnetic connector from the battery. Wipe the outside and inside of the bottom magnetic
connector with an isopropyl alcohol pad. Use an alcohol swab to wipe any excess oil out of the 510 connector.
Clean inside the air pathway with an alcohol swab. Using a circular motion, work your way up and down the air
pathway until you do not see any more oil.
Do not submerge any part of the device in a cleaning solution. Allow all parts to air dry prior to reassembly.
REMOVABLE MOUTHPIECE NOTE: The mouthpiece can be removed by pulling it from the device. It can be wiped
down with the isopropyl alcohol pad. Reattach the mouthpiece after it has completely dried.
WARNINGS
Do not expose to extreme temperatures or direct sunlight. Do not drop the device or accessories. Do not drop
or submerge in any liquid. Do not modify the electronics in any way. This device is intended for adults only. Do
not sell or provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. This
is not a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease, or
other conditions. Consult a physician before use, especially if you suffer from heart disease or any other medical
condition, or if you are pregnant or breastfeeding. Failure to follow any of these instructions could result in product
damage, property damage, personal injury, and may void warranty. Visit
PAGE 2
INSTRUCTION
MANUAL
PulsarShop.com
for warranty information.
PU-0782-24

Publicité

loading