Publicité
Wall Mount Assembly
Please follow below outline when wall mounting this fan.
1. Confirm the wall fan height required. Mark down the position the mounting bracket
would be located, see Fig.1.
2. Drill the three holes on the wall. Holes dimension should be 5/16"h diameter and
1-3/4" deep.
3. Insert the plastic anchors into the holes as shown in Fig 2.
4. Overlap the three holes on the mounting bracket with the drilled holes. Insert the
screws E into the holes and tighten as shown in Fig.3.
5. Overlap the hole C on the cradle base with the bigger hole D on the mounting bracket
and then insert the screw knob and tighten as shown in Fig.4.
Fig. 1
Fig. 3
Fan operation : Always operate the fan in the upright position. Follow all instructions
and recommendations outlined in this manual.
Fan connection : Plug fan directly into a grounded electrical outlet. Ensure the plug fits
tightly in the outlet. A loose connection may cause overheating and damage to the plug
or fan.
Note : To prevent overloading a circuit, do not plug the fan into a circuit that is servicing
other electrical items.
Turning Fan On : Place fan on stable Floor or Wall Mounted surface. Plug the fan into
a grounded electrical outlet . Turn the switch from the OFF position to the desired fan
speed.
Turning Fan Off : Turn the switch from the current fan speed setting to the OFF position.
Remove the plug from the electrical outlet.
OPERATING INSTRUCTIONS
Fig. 2
Fig. 4
-4-
Publicité
