ETI ALSD-6-9CP3-SV-TD-OS Guide D'utilisation Et D'entretien

NOTE: This fixture should be used on a 120-Volt fused circuit only 60Hz.
NOTE: Keep your receipt and these instructions for proof of purchase.
WARNING: Shut off the power at the circuit breaker or fuse panel before removing the old fixture,
ballast, or fluoresent tubes.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to
do the installation.
INSTALLATION
Can be installed into 5" and 6" housings.
1 Shut off power at the electrical panel before beginning the installation.
Remove fixture and set aside to recycle in accordance with local requirements.
2
NOTE: Stick the replacement label on the inner wall of the recessed housing before installation.
3 Remove lens by turning counter clockwise to unlock. Choose your favorite correlated color
temperature (CCT) before installing the fixture.
NOTE: The factory setting for the correlated color temperature (CCT) is 3000K, which is the
warmest white light.
INSTALLATION INTO RECESSED CAN USING
RETROFIT KIT (SOLD SEPARATELY)
4a Installing into a recessed can: Attach the friction clips (not included)
to the fixture. Adjust arrow on friction clip to aligns with the number
on fixture in order to achieve a tight fit inside the housing. (5" and 6"
means 5" and 6" can housing installation hole)
7a Screw E26 base adapter (not included) into socket in recessed
housing, and simply slide the trim and metal friction clips into the
housing.
USE AND CARE GUIDE
SURFACE MOUNT DISK LIGHT WITH OCCUPANCY SENSOR
RETROFIT KIT (SOLD SEPARATELY)*
Part
D
E
F
G
Hardware not shown to actual size.
*Retrofit mounting kit sold separately - Order # 70605101
Part # ALSD-6-RETROFIT KIT
5a Replace lens and twist clockwise to lock.
8a Carefully place wires into fixture and push
the fixture into the housing until flush with
ceiling.
Order # 63328102 Part # ALSD-6-9CP3-SV-TD-OS
PACKAGE CONTENTS
Part Description Quantity
A Fixture 1
B Screw 2
C Wire Connectors 3
A B
Description Quantity
Medium base (E26) 1
Socket Adapter
Screw 4
Wire Connector 3
Friction Clip 2
6a Make the electrical connections:
• Black wire to black wire.
• White wire to white wire.
• Use wire connectors to cover the wire
connections and cover with electrical tape.
Tuck wires inside the electrical box.
9a Caulk around the mounting surface edge
with silicone sealant.
C
D
E F G