Publicité
The time after the function switch off the fan:
Motor Speed level
1
2
3
4
5.3 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The
LED indicator blinks red regularly for 30
seconds if the grease filter must be cleaned.
The LED indicator blinks red twice per every
second for 30 seconds if the charcoal filter
must be replaced or cleaned.
This function activates independently
after 40 hours of operation for grease
filter and 160 hours of operation for
charcoal filter.
The fan does not operate during the
alarm. Fan starts to operate on last
remembered setting after 30 seconds.
Refer to cleaning the grease filter in care
and cleaning chapter.
6. CARE AND CLEANING
6.1 Notes on cleaning
Cleaning Agents
Time (min)
20
15
10
8
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in care and
cleaning chapter.
The function counter for charcoal filter is
disabled by default.
To activate or deactivate the counter for
charcoal filter:
1. Pull out the hood drawer.
2. Make sure that the fan is turned off.
3. Press
for 3 seconds.
The function is activated if two white LED
indicators flashes for 3 seconds. The function
is deactivated if only one LED indicator
flashes for 3 seconds.
To reset the function counter in the
notification period:
1. Pull out the hood drawer.
2. Press
for 3 seconds.
To reset the function counter out of the
notification period:
1. Pull out the hood drawer.
2. Make sure that the fan is turned off.
3. For grease filter press
4. For charcoal filter press
The indicator blinks once for correct reset.
68
for 3 seconds.
for 3 seconds.
Publicité
