Publicité
Battery Installation
Insert one size AA (LR6) battery each into the
transmitter and receiver units.
Battery life
Sony alkaline battery LR6 (N) (not supplied) will give
20 hour continuous operation of the transmitter and
receiver units respectively.
When to replace the batteries
When the battery becomes weak, the BATT indicator
fails to light up or becomes dimmer even if the
POWER switch is set to the ON position. In this case,
replace the battery with new one.
Notes on batteries
To avoid damage to the system caused by battery
leakage and corrosion;
—Install the batteries with the correct polarity.
—Do not try to recharge the batteries.
—Remove the batteries if the system is not to be used
for a long period of time.
In case of battery leakage, wipe off any deposit in the
battery compartments before installing new batteries.
How to Use
1-a Connect the receiver to the microphone jack of
your video camera recorder, and attach it to
the grip belt of your video camera recorder.
At this time, the built-in microphone of the video
camera recorder does not function.
1-b Connect the receiver to the microphone jack of
your tape recorder.
To monitor the sound being recorded
Connect the supplied earphtfne to the ® (earphone)
jack of the receiver.
2
Connect the lavalier microphone to the
transmitter unit and attach it to your clothes.
3
Select the radio frequency with the CHANNEL
selector switch.
Select the same position on the receiver and
transmitter units.
When successfully tuned, if the both units are in
operation, the indicator to the left of the
CHANNEL selector switch of the receiver unit
lights up.
4
Turn the power on.
The BATT indicator lights up.
Notes on turning the system on and off
You may hear some switching noise when you turn
the system on or off. To reduce the noise, take
following steps.
Turning on the system
Turn on the transmitter first, then the receiver.
Turning off the system
Turn off the receiver first, then the transmitter.
The maximum distance that the radio
transmission can reach
The optimum distance is up to approximately 150 feet
(45 m) without the system picking up some
interference. However, the distance may vary
according to the surroundings and environment. If
the system picks up some noise while using it within
the above mentioned distance, reduce the distance
between the transmitter unit and the receiver unit.
To record the ambient sound in the vicinity
of the video camera recorder at the same
time
Connect the optional microphone to the MIX MIC jack
of the receiver unit. You can mix the sound
transmitted by the transmitter unit and the sound
from the optional microphone.
Publicité
