Publicité
4. Using the Unit in Automatic Mode
IMPORTANT: If the unit's position changes after it has self-leveled,
verify the unit's position (for example, height) to the potentially
changed conditions.
1.
Slide the locking compensator/power
switch to the left to the unlocked
(ON)
position to power on the
unit. The level indicator and power
indicator will light up. (Figure 17)
Power/Battery LED:
2. On the keypad, press the
laser beam. Press the
beam. Press the
beam. The unit can be used with any combination of laser beams
turned on simultaneously. Disabling a laser you are not using
extends the life of the battery.
NOTE: The unit must be within ±4° of level for the self-leveling
feature to function properly. If the unit is beyond its 4° self-leveling
range, the laser will not self-level, the laser will flash, and the level
indicator status light will flash red. Once the unit has been adjusted
to within its 4° self-leveling range, the laser will self-level, the status
light will turn green, and the laser light will stop flashing and remain
solid.
©2023 Johnson Level & Tool - REV 1
Steady green LED indicates power is on
and battery power is greater than 30%.
Steady red LED indicates power is on and
battery power is between 30% and 15%.
Flashing red LED indicates power is on
and less than 10%. Charge or change the
batteries.
Extinguished LED indicates power is off or
battery has been depleted.
button to turn on the horizontal
button to turn on the right vertical laser
button to turn on the front vertical laser
Figure 17
15
Publicité
