Publicité
Liens rapides
Installation
1
Determining the mounting
location
NOTE:
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads in the general
direction of the desired light coverage.
2
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
NOTE: Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□
□
Install the mounting bracket (EE) on
the junction box. Use the mounting bracket
box. If necessary, use the screws that were
□
Firmly pull on the mounting bracket (EE) to
verify it is securely mounted to the junction
box.
Quick Start Guide
Motion Activated Security Light
EE
BB or CC
Model # IS09a15008WD-BK
Wall Mount
3
Making the electrical
connections
□
Connect the white wire of the xture to the white
wire from the junction box with wire nut(DD).
□
Connect the black wire of the xture to the black
wire from the junction box with wire nut(DD).
DD
Please contact 1-866-308-3976 for further assistance.
SKU # 1001 857 557
1001 857 552
IS09a15008WD-WH
A
Eave Mount
HOMEDEPOT.CA
Publicité
Manuels Connexes pour Defiant IS09a15008WD-BK
Sommaire des Matières pour Defiant IS09a15008WD-BK
- Page 1 Quick Start Guide SKU # 1001 857 557 Motion Activated Security Light 1001 857 552 Model # IS09a15008WD-BK IS09a15008WD-WH Installation Determining the mounting location NOTE: mounted higher than recommended, aiming the sensor down will reduce the coverage area. Wall Mount □...
- Page 2 Installation (continued) Mounting the light fixture □ Align the xture with the mounting plate (EE). And then tighten the mounting screw (CC) securely through the side of the mounting plate (EE). Do not over tighten. □ Push the rubber plug (AA) rmly into the mounting bolt hole on the light xture.
- Page 3 Operation Turn the power on at the circuit breaker or fuse and turn on the wall switch. The fixture will into test mode and light on for 3~5 seconds. Care and Cleaning □ □ □ Troubleshooting Problem Possible Cause Solution □...
- Page 4 Guide de démarrage rapide Lumière SKU # 1001 857 557 SKU # 1001 857 557 de sécurité activée par le mouvement 1001 857 552 1001 857 552 MODÈLE # IS09a15008WD-BK IS09a15008WD-WH Installation Détermination du lieu de l’installation REMARQUE: Ce luminaire devrait être installé à...
- Page 5 Installation (Continué) Montage du luminaire □ Alignez le luminaire avec la plaque de montage (EE). Serrez ensuite fermement le vis du support de montage (CC) au côté de la plaque de montage (EE). Ne pas trop serrer. □ Poussez fermement le bouchon en caoutchouc (AA) dans le trou du boulon de montage du luminaire.
- Page 6 Opération Mettez sous tension au niveau du disjoncteur ou du fusible et allumez l’interrupteur mural. L'appareil passera en mode test et s'allumera pendant 3 à 5 secondes. Entretien et nettoyage □ Pour prolonger l’apparence originale, nettoyez uniquement au moyen d’un chiffon doux trempé dans de l’eau. □...