Publicité
5.4
Detach front cover
2.
1.
Fig. 4: Detach front cover
In the delivery state, the front cover is not attached.
The front cover is included in the scope of delivery.
u If necessary, loosen the front cover using the
tool (supplied).
5.5
Opening the product
The tasks described in this section may only
be carried out by a qualified electrician.
Fig. 5: Open the product
When delivered, the top section of the housing is
not attached with screws. The screws are included
in the scope of delivery.
u Detach front cover, if necessary.
1 "5.4 Detach front cover" [} 14]
u Unscrew screws, if necessary.
14
u Flip down the top section of the housing.
5.6
Installing the product on the wall
5.6.1 Creating drill holes
ATTENTION
Material damage due to uneven surface
Installing on an uneven surface can cause the hous-
ing to go out of shape, so that the protection class
is no longer guaranteed. Consequential damage of
electronic components can occur.
u Only install the product on an even surface.
u If necessary, level out uneven surfaces with
suitable measures.
MENNEKES recommends installing at an er-
gonomically sensible height depending on
the height of the body.
ATTENTION
Material damage due to drilling dust
Consequential damage of electronic components
can occur if drilling dust gets into the product.
u Make sure that drilling dust does not get into
the product.
u Do not use the product as a drilling template
and do not drill through the product.
Publicité
