Publicité
Thank you for purchasing a San Jamar digital scale. Please read the
following operation information to ensure the proper function of your new scale.
AC/DC ADAPTER (OPTIONAL)
1. Plug the adapter jack into the socket.
2. Plug the adapter to the AC main.
LEVEL THE SCALE
When the scale is put to use at a new location, adjust the level of the scale by
turning the 4 level adjusting feet until the bubble is located in the middle position of
the bubble leveler.
POWER OFF
1. The scale can be powered off manually by pressing the ON/OFF key.
ACTIVATING THE SCALE
1. Turn the scale on by pressing ON/OFF key.
2. The LCD screen will show all characters for a few seconds, and then "0.000 "
will be shown on the display.
3. The scale turns off automatically after being idle for two minutes.
BACK LIGHT
1. You can turn the BACK LIGHT on or off by pressing the BACK LIGHT key.
PRODUCT SPECIFICATIONS
Model: SCDG33BK
Capacity: 33 lb / 15 kg
Graduation: 0.1 oz / 1 g
Platform Dimensions: 8" x 6.25"
Product Dimensions: 8.25" x 8.5" x 3.75"
Power Source: 4 - C Batteries
Automatic Shut-off: 2 minutes
NSF Certified
2
WEIGHING AN ITEM
1. Turn on the scale.
2. Place an item on the platform.
3. The weight of the item will be displayed.
SELECTING WEIGHT UNIT
While the scale is on, press the UNITS button to move right-aligned arrow
through unit options.
USING THE HOLD FUNCTION
While an item is on the platform, press the HOLD key once and then remove the
item. The scale will continue to hold the original weight for 10 seconds.
USING THE TARE MODE
1. Turn the scale on.
2. Place an item on the weighing platform, weight value will display.
3. Press the TARE key. The weight of the item will return to "0.000 ."
4. Place next item on the platform and note the reading.
5. Press TARE key again to show the total weight of only the added item.
NOTE: The scale will display a negative reading when you remove all items. Press
the TARE key once, and the negative reading will disappear.
USING THE COUNTING MODE: SET SAMPLE SIZE
1. Turn on the scale.
2. Press and hold the PCS key for about 3 seconds until a flashing number
is displayed.
3. Press the MODE key to select the sample size in the sequence of 10 → 20 →
40 → 60 → 80 → 100
4. Once you have determined your desired sample size; place the samples on
the platform. (Example: For a sample size of 10, place quantity of 10 onto the
platform, for sample size of 20, place quantity of 20, etc.)
5. Press the PCS key to confirm the sample size. You can now add, and
subtract samples.
6. Press the PCS key again to return to weighing mode.
Remark: By pressing the TARE key; this will activate the accumulation of counting.
See Tare Mode Steps
In order to ensure accurate counting figure, the minimum unit sample weight must
be > ld, and the counting size must not exceed 65535 pcs. If over 65535 pcs, the
LCD will display "- - - -"
3
Publicité
