Publicité
8. In order to catch all the hair, move the trimmer several times through the same section
of the hair.
BEARD TRIMMER ATTACHMENT.
1. Attach the beard trimmer attachment to the device housing.
2.
Move the guide comb (3/4/5/6mm) so that the desired cutting length locks into
place.
NOTE: Use the beard trimmer without the guide comb to cut your beard very short or
to cut moustache and contours .
3.
ALWAYS ensure your beard is clean, well combed, tangle-free and dry before using
the appliance.
4.
Position the comb on the beard and cut from below to above against the direction
of the beard hair growth.
5.
Cut the beard from the ear to the chin downwards. First trim one side and after
the other one.
NOTE: The cutting edge of the beard trimmer is set at a right angle to the beard.
6.
In order to cut your moustache, first comb it straight down. Start trimming from
the middle of the mouth, first cut one side and after the other.
NOSE & EAR TRIMMER.
Use the nose and ear trimmer attachment to trim undesired hair from your nose and/or ears.
1. Attach the nose and ear trimmer attachment to the device housing.
2. Make sure your nostrils/ears are clean.
3. Introduce the tip of the trimmer into one nostril. DO NOT penetrate the tip of this
accessory more than 0.5 cm inside the nostrils.
4. Move the trimmer gently in and out of the nostril while simultaneously spinning it to
trim undesired hair.
5. Move the tip of the nose and ear trimmer gently around the ears to trim external hair.
6. Carefully introduce the nose and ear trimmer tip into the outer portion of the ear canal.
7. DO NOT insert it more than 0.5 cm into the ear canal to prevent damaging your
eardrums.
Publicité
