Publicité
Press the ON/OFF button on the panel (4) for the plate you want to use; the display shows "----".
-
1) Cooking with power regulation
Touch the "+" button that is below the hob you want to use. Unit turns on and display shows "1000W".
-
-
Using the keys "+" and "-" or using the central slider (8) it is possible to change the power and thus the
amount of heat transmitted.
Power on left plate can be set on: 200, 400, 600, 800, 1000, 1200, 1400, 1600, 1800W.
Power on right plate can be set on: 200, 400, 600, 800, 1000, 1200, 1400, 1600, 1700W.
Press the Boost button (5) to activate the maximum power immediately.
After cooking, push the ON / OFF button, to turn off the appliance. Left display shows "L".
-
1A) Timer after power regulation
Press Timer (6) during cooking. The display shows "0".
-
With the keys "+" e "-" set the duration of cooking, up to 180 minutes.
-
-
Display will show for some seconds the time set.
-
During cooking on the display will appear the power selected, and the time set.
-
Cooking will stop automatically when time finishes.
KEY LOCK
To lock the keypad on the control panel (4) press the key "Lock" (10) during use. On
display appears "Lo" to indicate the lock. To unlock press together the key "Lock" for 3 seconds.
SAFETY DEVICE
The unit turns off automatically if there is any pan placed on it, or it is removed, or it is made of such a
material not suitable for induction cooking. In this case, the unit will show and goes into stand-by. Every time
you turn off the appliance by pressing the ON / OFF button, the fan will continue to run until cooling down of
any part of the unit. To turn off the product, always push the ON / OFF button, do not turn it off by removing
the cooking container or by unplugging the unit.
ERROR MESSAGE
Error
E0/E1
High or low Voltage
E2
Crystal plate is overheating.
E3
Internal overheating
E5/E6
Temperature sensor failure.
E7
Not suitable vessel.
Vessel is not placed inside
the cooking area.
No vessel.
CLEANING -
Unplug the unit from the electrical power outlet and wait for the complete cooling
down of every parts before starting cleaning. Do not immerse in water and never leave the appliance under
the jet of tap water. In any case, prevent water or other liquids to flow on the surfaces. Do not use abrasive or
metal sponges for cleaning. Clean the cooking plate with a damp sponge.
Cause
Plug on a suitable electrical power outlet.
Let the plate cool down for and remove what is overheating the
glass. Restart operation only when the plate is cool.
Let the plate cool down and check the ventilation fan is not
obstructed, refer to an Authorized Service since the thermostat
could be defective.
Refer to Authorized Service since thermostat could be defective
Use only pans suitable with induction cooking.
Place the vessel on the cooking area.
Control panel (4)
Solution
13
Publicité
