Connect With Your Horizon Box; Connect With Your Tv Set - ups HORIZON Mode D'emploi

CONNECT WITH YOUR
HORIZON BOX
Pair the new Horizon remote control with your Horizon box to
enjoy the full experience of Horizon (ensure the pull out tab
has already been removed from the battery compartment).
1. Make sure that your Horizon box is turned on and that
there is a clear line of sight between the Horizon box and
the remote control.
2. Turn the remote control with the keyboard side facing up.
3. Press and hold the pairing key for 10 seconds aiming at the
Horizon box (see picture).
4. If pairing is successful you will see a notification on your
TV set.
TV MODEL CODE LIST
B&O 0314 Lenco
Euroline 0955 LG
Finlux 1004 Loewe
Fujitsu 1052 Metz
Grundig 1162 NEC
JVC 1464 Panasonic
Kenwood 1507 Philips
Is your TV brand not on the list?
Look at the online user manual for a complete overview of TV
model codes: upc.ch/remote-codes-en.pdf
30
PAIRING KEY
PRESS FOR 10 SEC.
1615 Pioneer 2212
1628 Samsung 2448
1660 Sharp 2550
1810 Sony 2679
1950 Toshiba 3021
2153 Vestel 3148
2195
CONNECT WITH YOUR
TV SET
You can also pair the remote control with your TV set to switch
your TV on or off and adjust the volume.
1. Look up your TV brand code (see page 30).
2. Switch off the Horizon box and switch on your television.
3. First, press both the VOL button and the TV Source
button for 5 seconds until the TV ON/OFF button flashes
3 times.
4. Enter the TV brand code via the keypad within 10 seconds.
5. Point the Horizon remote control at your TV set and hold
down the TV ON/OFF button for up to 1 min. until the TV
turns off. If your TV does not turn off, repeat steps 2 to 5.
6. As soon as your TV has switched itself off, again press
the VOL button and the TV Source button until the
TV ON/OFF button flashes 3 times.
ATTENTION: If you wait too long after the TV has switched
itself off, an incorrect code may be memorised. If this is the
case, please repeat the procedure.
TV ON/OFF
VOL
ENGLISH
TV SOURCE
31