Publicité
•
Before each cleaning session or repair, switch off the appliance. Then pull the power plug out
of the socket. The appliance should neither be cleaned in a jet of water nor with a high pressure
spray. The motor unit must not be immersed in water.
•
Never do attempt to repair the appliance by yourself. Repairs may only be undertaken by a
qualified specialist using original spare parts.
•
If you do not like to use the appliance for a longer time, then unplug and clean the appliance.
3. Start up
•
Before the first use clean all parts throughly with a soft damp cloth and a mild commercial
detergent (see point 4 "Cleaning").
•
Plug the power plug into a suitable outlet.
•
Put the container with the contents on the motor base. Make sure that the cutting unit is
completely covered.
•
Small food additions or liquids, which are to be added during mixing, can be given by removing
of the cap for a short period of time.
•
First pour liquids and then give firm food into the container.
•
The mixer must be used with a minimum of liquid in the container, especially if you crush ice
cubes, but only in small cube sizes.
•
Fruit, vegetable, meat etc., must be cut in small pieces before mixing. The pieces should not
be bigger than 2 cm.
•
Do not fill up the container completely and add the food in small quantities.
•
Place the lid with the lid insert correctly on the container.
•
Switch on the mixer by pushing the ON/OFF switch (9)
•
Always start the mixer in the low level or with one of the keys "35" – "60" or "90".
•
The keys "35" - "60" and "90" are programmed for an automatic mixing process and also for
switching off.
Programming proceedings
•
The button 35 is for slow motion up to the high speed. After 35 seconds the mixer switches off
automatically.
•
The button 60 is for the slow motion up to high speed and the one more repetition. After 60
seconds the mixer switches off automatically.
•
The button 90 is for slow motion up to high speed and the four time repetition. After 90 seconds
the mixer switches off automatically.
•
The HIGH, MEDIUM and LOW buttons have no automatic switching off. If you select one of
these buttons, the mixer will stay in operation for this speed. To turn off the mixer, it is enough
to press any button. You obtain the fastet speed, by keeping the pulse function button pressed.
•
The power will be switch off automatically, if the motor is overloaded. For example: If something
blocks the cutting unit, the motor can be overheated. In this case pull the plug from the socket
and give the contents into another bowl. Allow the mixer to cool down. Press the reset button
(on back or on the underside, depending on model) to start again.
Operating Instructions MIXER / BLENDER Modell TM 800
10/39
page 3/5
Publicité
