Publicité
Initial Setup
Essential Setup
Place the unit on a flat and level surface. The selected location should be stable and free from
1.
vibration.
2.
Remove the tie-wrap that is holding the tonearm.
Place the slip mat on top of the turntable platter.
3.
Connect the speakers to the Spring clip speaker terminals of the turntable.
4.
Connect AC adaptor to the Power Jack of the unit.
5.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Stereo System Connection
Spring clip speaker terminals
The spring clip speaker terminals deliver amplified, speaker-level signals as output and should be
connected with the passive speakers.
RCA Jacks
The RCA Jacks output analog line-level signals and could be connected directly with a pair of
•
active/powered speakers or the appropriate input of your stereo system.
The Red plug connects with the Right channel and the White plug connects with the Left
•
channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered speakers. If connected to the passive
speakers, the volume level will be very low.
Aux Input Connection
You can connect an audio device to this unit and play your music through its speakers. To do this, rotate
the Function Knob to Aux In mode, connect the 3.5mm auxiliary cable between your audio device and
the Aux In Jack of this unit and start playing.
Turntable Operation
1. Rotate the Power / Volume Knob to turn on the power.
2. Set the Function Switch to PHONO position.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever the turntable is being moved or
cleaned.
6. Release the tonearm Hold Down Clip.
Note: when the turntable is not in use, remember to lock back hold down clip.
7. Lift up the tonearm and move it over the record where play is desired to begin. Gently put down the
tonearm and begin the playback.
8. When the record is finished playing, gently lift up the tone arm, and move it back to the tonearm
rest.
9. Lock the Hold Down Clip to secure the tonearm.
English
Publicité
