Publicité
Liens rapides
g
GE
Lighting Solutions
READ THOROUGHLY BEFORE INSTALLING
WARNING
Risk of electric shock
• Turn power off before servicing
– see instructions
NOTE: Make all electrical connections in accor-
dance with the National Electrical Code and any
applicable local code requirements.
WARNING
Risk of fire
• Keep combustible materials away
from lens – see instructions
• Use lamps specified on nameplate
NOTE: Do not place combustible materials within
7 feet (2 meters) of the front of the reflector lens.
This luminaire is designed for use in outdoor applica-
tions and must adhere to 25°C Max. ambient tempera-
ture limitation unless otherwise stated on nameplate.
Install and maintain it according to the following recom-
mendations.
NOTE: Verify that supply voltage is correct by
comparing it to nameplate.
SERVICE
CONSIDERATIONS
Ballast Compartment
DO NOT REMOVE THIS COVER!—There are
no field serviceable components under this
cover. Ballasting components must be
maintained by factory trained service techni-
cians only.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation
or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser's purposes, the matter should be
referred to GE Lighting Solutions.
Sealed Reflector Assembly
Luminaire is equipped with
a safety circuit to prevent lamp
operation if the lens is broken.
If any component such as
reflector, lens or casing is
damaged the complete
assembly must be replaced.
Relamping Door
Luminaire is shipped with
lamp in place. Door may be
opened for relamping. Door
must be sealed during opera-
tion.
Ultra Sport
with Hot Restart Option
Unit will fall if not installed properly
• Follow installation instructions
STEP 1 — INSTALLATION PROCEDURES
Verify that the drain holes are in the proper locations
for the intended aiming direction. If not contact the
factory.
Drain holes for
fixtures aimed below
horizontal.
STEP 2 — LUMINAIRE MOUNTING
Reference Mark
Angle Indicator
Adjustment
INSTRUCTIONS
Luminaire
TM
CAUTION
Drain holes for
fixtures aimed above
horizontal.
Bolts (2)
Crossarm Adapter
and Hardware (not supplied)
GEH-5900
Publicité
Manuels Connexes pour GE Ultra Sport GEH-5900
Sommaire des Matières pour GE Ultra Sport GEH-5900
- Page 1 These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred to GE Lighting Solutions.
- Page 2 Step 4 Step 3 — LUMINAIRE AIMING Two sighting systems are provided for your convenience. Use the sight system which is most easily accessed. Optical Sight: A . Rotate sight into vertical position. B . Align the reference mark of top of reflector flange with notch in sight for proper aiming.
- Page 3 REMOTE BALLAST MOUNTING See below illustration for bolt spacing and bracket minimum spacing.
- Page 5 Ces instructions n'ont pas pour destination de couvrir tous les détails ou variantes de l'équipement, ni de répondre à toutes les éventualités que vous pourriez rencontrer pendant l'installation, le fonctionnement ou l'entretien. Si vous souhaitez des informations complémentaires, ou si vous rencontrez un problème particulier qui ne soit pas adressé de votre point de vue d'acheteur, le sujet doit être remonté jusqu'à la société GE Lighting Solutions...
- Page 6 Étape 4 Step 3 — ORIENTATION DU LUMINAIRE Deux systèmes de visée sont offerts à l'utilisateur. Employez celui qui vous semble le plus accessible. Marque de Visée optique : Dispositif de visée référence abaissé en position A. Faites tourner le viseur jusqu'à la position verticale.
- Page 7 INSTALLATION DU BALLAST DISTANT L'illustration ci-dessous indique l'espacement des boulons et l'espacement minimum du support. Surface verticale...
- Page 8 4 3 5 3 3 GE Lighting Solutions is a subsidiary of the General Electric Company. Evolve and other trademarks belong to GE Lighting Solutions. The GE brand and logo are trademarks of the General Electric Company. © 2011 GE Lighting Solutions. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.