Publicité
SET UP
Place the heating unit on a firm, level surface free of obstructions and at least 3 ft. (0.9 m) away from any combustible materials.
DO NOT use on an unstable surface such as bedding or deep carpeting.
OPERATION
This Section will explain the function of each convenient control.
The heater may emit a slight, harmless odor when first used. This odor is a normal condition
caused by initial heating of internal heater parts and will not occur again.
fIREPLACE CONTROL PANEL
To access control panel, push on the middle top of door or on other models pull down on the top lip of the door.
To locate controls refer to FiGUre 1
a – On/OFF BUTTOn: The fireplace on/off switch supplies the main power
to the fireplace.
B – FlaMe DiMMer BUTTOn: The flame dimmer button is used to increase
or decrease the brightness of the flame and embers. Press once, the fireplace
will continuously scroll through every brightness option. Press again to lock
in your choice.
C – HeaTer lOw MODe BUTTOn: The heater low button is used to turn
the heater on or off in the low power setting.
D – HeaTer HiGH MODe BUTTOn: The heater high button is used to turn the heater on or off in the high power setting.
CONTROL PANEL INDICATOR LIGhTS
This is the power indicator, it is lit when the fireplace main power is turned on and is dark when the fireplace main power
is turned off.
This indicates the current mode of the simulated flame and embers. it is lit when the main power is on. it is blinking in the
brightness option mode and it is dark when the main power is off.
This indicates the heater is working in low-power mode.
This indicates the heater is working in high-power mode.
3
(FiGUre 1)
Publicité
