Publicité
On this model, the receiver of the remote control is already installed into the motor cover.
Make the following electrical connections :
1/ Connections from ceiling fan to hanger bracket
- Connect the connector of the hanger bracket (3 wires : brown or black/blue/yellow and
green) to that of the ceiling fan.
2/ Connections from hanger bracket to AC power
By using the connecting terminals provided on the hanger bracket :
- Connect the phase of the ceiling with the phase of the hanger bracket in the connecting
terminal L.
- Connect the neutral of the ceiling with the neutral of the hanger bracket in the connecting
terminal N.
3/ Grounding
- Connect the ground wire of the ceiling to that of the hanger bracket in the connecting
terminal E.
- Connect one of the two grounding connectors of the hanger bracket to that of the hanger
ball of down rod.
- Connect the other grounding connector of the hanger bracket to that of the ceiling fan.
Check that all electrical connections have been correctly made and that the receiver
and the wires are properly stored in the hanger bracket.
Mount the canopy on the hanger bracket, place it correctly by inserting the 2 screws of the
hanger bracket in the notches of the canopy, turn the canopy until the screws lock in the
notches and tighten the screws if necessary. Be careful to not pinch a wire.
10. USING THE REMOTE CONTROL
Once your ceiling fan is fully assembled and installed, insert the supplied battery into your
remote control and turn on the power.
Operation
Press the POWER button to turn your ceiling fan on or off.
Press the + button to increase the speed (6 speeds), the
corresponding LED of the selected speed lights on.
Press the - button to decrease the speed (6 speeds), the
corresponding LED of the selected speed lights on.
Press the LIGHT button to turn the light on or off.
Press the TIMER button to set the timer (automatic stop once the selected time has been
reached), the corresponding LEDs light on: 1 LED = 1 hour / 2 LED = 2 hours / 3 LED = 4
hours / 4 LED = 8 hours. To deactivate the timer, press until all LEDs light off.
21
Publicité
