Publicité
ASHDOWN ENGINEERING - CTM-300
USER GUIDE
FACILITIES AND CONTROLS (
)
NOTE THAT THESE VARY ACCORDING TO THE MODEL
INPUTS
There are two instrument inputs marked LOW and HIGH. The LOW input is
highly sensitivity and also high impedance to suit the output from PASSIVE (Low
Output) basses - The HIGH input is low sensitivity and lower impedance to suit
the output from ACTIVE (High Output) basses. Plugging an active (High Output)
bass into the LOW input will overload the input, creating a fatter, warmer and
more distorted sound. Experiment by plugging your bass into either input to
achieve the desired sound. On models with a single input this will be suitable for
both Passive and Active basses.
EFFECTS SEND AND RETURN
These 1/4" jack sockets should be used to connect to an external effects device
or pedal board. The EFFECTS SEND output should connect to the INPUT of
the effects unit, and the output of the effects unit should be connected to the
EFFECTS RETURN input Note that the signal level is at instrument level so this
loop is suitable for effects pedals.
EQ CONTROLS
Use the MIDDLE, BASS and TREBLE controls to effect the overall tone of the
sound.
MID SHIFT
Causes the MIDDLE control to operate at different points in the frequency
spectrum dependant on the button being either in or out.
Publicité
