Publicité
Condition Your
Filtration System
Before drinking from the Gravity Water System is it important to condition
the filtration system as follows: run two Upper Tanks of water through the
system. Remove the Lower Tank from the system, and discard the water
(or give it to your plants). Thoroughly rinse the Lower Tank to remove any
excess filter media. Return the Lower Tank to the system. Place Mineral
Stones in the Lower Tank.
One full Upper Tank takes approximately three hours to filter. If it takes
longer than three hours to filter an Upper Tank of water, scrub your
Ceramic Pre-filter some more with the sponge included with your Gravity
Water System or scrub with a clean abrasive sponge (like the green side of
a Scotch-Brite sponge).
Long Contact Filtration
The Gravity Water System uses long-contact filtration to provide the
highest level of contaminant reduction. The Ceramic Pre-filter drips water
slowly through the system to ensure that the middle filter has a long
period of contact with the water to remove contaminants.
Because of the Gravity Water System's large reservoir, you should always
have water available a er the initial condition and fill. You will only need to
fill the Upper Tank every 1-2 days depending on how many people drink
from it.
Tip: fill the Upper Tank at night to ensure the Lower Tank
is replenished by morning.
DO NOT fill the Upper Tank if the Lower Tank is completely
full as this will cause the Lower Tank to overflow.
Visit
santevia.com/testing
of filtration test results.
English
for the complete list
support.santevia.com
Publicité
