LEGRAND 430 521 Manuel D'utilisation page 25

IN-CEILING MOUNT INSTALLATION
a Remove the ceiling tile from the ceiling and cut
a hole whose diameter is 110mm on the ceiling
tile to pass the wires and cables through to the
upside of ceiling.
c Align the dome cover stud with the dome cover
$
assembly stud and slightly push the dome cover
$
$
to the ceiling tile.
Important Notice
• Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
b Connect the wiring and cabling and attach the
camera to the ceiling tile. (Tapping M4x16)
d Turn the dome cover clockwise and screw on
the dome cover lock-up screw. Then remove the
protection vinyl from the dome cover.
(Machine M3x6)
25