Publicité
Insert the mains plug into the mains
♦
socket.
When charging is complete, disconnect
♦
the charger
from the mains.
Pull the battery pack
♦
charger
.
Switch off the charger for at least
♦
15 minutes between successive charging
sessions. Also disconnect the mains plug.
Inserting/removing the battery
pack
Inserting the battery pack
Allow the battery pack
♦
place in the appliance.
Removing the battery pack
Press the release button
♦
the battery pack
Checking the battery charge level
Press the battery charge level button
♦
to check the status of the battery (see
also main diagram). The status will be
shown on the battery display LED
follows:
RED/ORANGE/GREEN = maximum
charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Using the appliance
Switching on/off
Switching on
First, press the safety lock-out
♦
Then press and hold the ON/OFF switch
♦
. You can now release the safety lock-
out
.
|
8
GB / IE
out of the
to click into
and remove
.
as
.
Switching off
Release the ON/OFF switch
♦
NOTE
For safety reasons, the ON/OFF switch
►
cannot be locked.
Setting the cut depth
Use the dial
to adjust the cutting depth
(0–2 mm) in 1/5 mm increments using the
cutting depth scale
read via the
marking.
Vacuuming dust/chips (see fig. A)
WARNING!
Always wear a dust mask!
RISK OF INJURY!
Always switch the appliance off and
►
remove the battery before carrying out
any work on the appliance.
Adjustable chip ejector (left/right)
Unlock the chip ejector
♦
the opposite direction to the arrow (from
the "LOCK" position).
Pull the chip ejector
♦
ance.
The chip ejector
♦
the plane on the left or the right. Make
sure that the tab on the chip ejector
fits into the corresponding recess on the
housing.
Push the chip ejector
♦
ance.
Lock the chip ejector
♦
the position "LOCK".
External extraction
When using a workshop extractor, for
example, it may be necessary to use the
adapter for external extraction
workshop vacuum cleaner must be suitable
for the material being processed.
.
. This can then be
by turning it in
out of the appli-
can be attached to
into the appli-
by turning it to
. The
Publicité
