Publicité
Les langues disponibles
Les langues disponibles
Before inspecting, carrying out any maintenance or
cleaning tasks, switch off the demolition hammer and
unplug the power cord.
The motor will not start if the carbon brushes are worn out.
The carbon brushes must be replaced in time, otherwise
there will be poor contact between the carbon brushes and
the rotor, which may lead to sparks and damage to the
power tool. Both carbon brushes should be replaced at the
same
time
by
two
characteristics.
1. Unplug the power cord (9);
2. Remove the carbon brush cap (10);
3. Remove the worn-out carbon brushes and install the new
ones, while paying attention to their position;
4. Place the carbon brush cap.
The demolition hammer does not require constant or daily
lubrication as it has a built-in lubrication system. However,
it is recommended to replace the grease periodically for a
longer service life of the hammer.
Cleaning
After each use, clean all the components of the demolition
hammer. Clean the demolition hammer with a clean, damp
cloth and blow it out with compressed air at low pressure.
Regularly remove and clean the grease accumulated inside
the chuck.
Careful handling protects the power tool and extends its
service life.
The power tool and its ventilation slots must be kept clean.
Clean the ventilation slots regularly or whenever they
become blocked.
Storage
When not in use, store the demolition hammer in a dry,
clean place, free of corrosive smoke and out of children's
reach. Keep the hammer in its original packaging.
carbon
brushes
with
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
equal
You can get information regarding the disposal of the power
tool through the authority in charge of recycling in your city.
WhatsApp:
E-mail:
+351 967 817 569
support@vito-tools.com
Publicité
