Publicité
Les langues disponibles
Les langues disponibles
The hammer has been designed to perform chiselling
operations in concrete, brick, stone and asphalt.
While working with the demolition hammer, you should
take into consideration some cares and procedures of use:
▪ If the impact accessory jams, switch off the demolition
hammer immediately. Avoid high reaction torques that
cause kickback;
▪ Always work with the auxiliary handle fitted and hold the
hammer with both hands. Loss of control of the
demolition hammer can cause serious injury;
▪ Do not apply too much pressure on the demolition
hammer against the workpiece/object. If the speed
drops abruptly, reduce the pressure on the hammer
immediately;
▪ Never put down the demolition hammer before the drill
bit, pointed or flat chisel, has completely stopped;
▪ Wear
hearing
rotary/demolition hammers. Exposure to noise can cause
hearing loss;
▪ Work in such a way that the power cord is always behind
the hammer during operation;
▪ Switch off the demolition hammer immediately if any of
the following problems occur:
- Sparks in the brushes and smoke appearance;
- Grease leakage through the ventilation slots;
- Damage on the demolition hammer housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or a burning smell.
protection
while
1. Fit the impact accessory into the chuck hole (2);
2. If using a chisel, adjust the position to the required
direction;
3. Press the "ON/OFF" switch (6) and touch the chisel to the
surface to be chiselled;
4. Press the hammer in the direction of the surface to be
drilled/chiselled. It is not necessary to apply too much
pressure;
5. To switch off the demolition hammer, release the
"ON/OFF" switch.
To adjust the position of the chisel, pull the chisel position
regulator (3) and turn it until the chisel is in the desired
position. Make sure the regulator is in the initial position
before starting the work.
operating
Publicité
