Publicité
9
TECHNICAL DATA
WARNING
Read this manual carefully before using the machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the enclosed safety instructions as well as the additional safety
instructions
The following symbols are used throughout this manual
Denotes risk of personal injury or damage to the tool
Caution! Read the instruction manual and follow the warning and safety instructions!
Before start-up, note the following!
- The pump can be connected to any shock-proof plug which has been installed according to regulations.
The plug must have a supply voltage of 230V~50Hz. Fuse min. 6 amp.
Warning! When the pump is to be used near swimming pools or garden ponds and in their area of
protection, it must be equipped with a ground-fault circuit interruptor with a nominal trip current of max. 30
mA. The pump must not be operated while people are in the swimming pool or in the garden pond! Please
contact your electrician!
Attention!
(Important for your own security)
Before starting to run your new submersible pump, please have the following items checked by an expert:
- Ground connection
- Zero conductor
- Fault current breaker switch must correspond the safety regulations of the power plants and they must
work faultlessly.
- The electrical connections must be protected from moisture.
- If there is danger of looding, the electrical connections must be taken to higher ground.
- Circulation of aggressive fluids, as well as the circulation of abrasive materials must be avoided at all
costs.
- The submersible motor-driven pump must be protected from frost.
- The pump must be protected from running dry.
Access on the part of children should also be prevented with appropriate measures.
pump by suspending it unsupported from its delivery pipe or power cable.
Mains supply
Your new water pump is equipped with a shock-proof plug according to regulations. The pump is designed
to be connect-ed to a 220/230V~50Hz safety socket. Make sure that the socket is sufficiently secured
(min. 6 Amp.) and is in excellent condition. Introduce the plug into the socket and the pump is ready to g
Important Note! If the mains cable or plug suffers any damage from external action, repairs to the cable
are prohibited.
Important! This work may only be performed by a qualified electrician.
Setting to work
After having read these instructions carefully, you can set your pump to work, reconsidering the following
items:
- Check if electrical connection is 230 V~50 Hz
- Check if socket is in good condition.
- Make sure that water and humidity can never come to the mains supply.
- Avoid pump running dry.
Important! Note! Remove the mains plug before all maintenance work. Every 3 months the shaft ground
Publicité
