Publicité
• Never put objects through the protective grille into
the product.
• Objects that can be pulled (e. g. curtains, plants),
must not be in the immediate vicinity.
• Never expose the product to water or other liq-
uids.
• The product must not be operated in rooms with
bathtubs, showers or swimming pools or near to
wash basins or water connections.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• If the power cord of this device is damaged, it
must be replaced by the manufacturer, its cus-
tomer service department or a similarly qualified
person, in order to avoid potential hazards.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
Unpacking and assembly
Unpacking
Unpacking the product and checking for complete-
ness.
Scope of delivery
• Table fan
• Instructions for use
Your product at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
Operation
Check before switching on!
DANGER! Caution, risk of injury! The
product may only be put into operation if no
faults are found during the check-up. Ensure
that any defective parts are replaced before
the product is used again.
Note: To avoid overloading the circuit, do
not operate the other devices on the same
circuit.
Check the safe condition of the product:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
Switching On/Off
► Operation – p. 2
Fault/malfunction
Product not running.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
– Set it to [0] position, insert the plug into the power
– OFF: Turn it to [0] position, fan is set to stop work-
– High Speed and Swing: Turn it to [
– Medium Speed and Swing: Turn it to [ ] position,
– Low Speed and Swing: Turn it to [ ] position, fan
– High Speed: Turn it to [3] position, fan is set in
– Medium Speed: Turn it to [2] position, fan is set in
– Low Speed: Turn it to [1] position, fan is set in low
Cleaning
– Turn off the product, pull out the mains plug.
– Wipe the product with a slightly damp cloth.
Storage and transport
Storing
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
– If the device is not used for an extended period
Transport
– Use the original packaging to ship whenever pos-
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No mains voltage?
Cable faulty?
source (socket).
ing.
fan is set in high level speed and swing working
state.
fan is set in medium level speed and swing work-
ing state.
is set in low level speed and swing working state.
high level speed working state.
medium level speed working state.
level speed working state.
DANGER! Caution, risk of injury! Always
pull the mains plug out before commencing
any work on the product.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
(overwintering), store it in a dry frost-free location.
sible.
DANGER! Risk of injury! Improper repairs
can result in the product functioning
unsafely. This endangers yourself and your
environment.
Remedy
Check cable, plug, socket and fuse.
Contact your local vendor.
GB
] position,
13
Publicité
