Publicité
Assembly and Instruction Procedure:
Every carton should contain a top section and a bottom section
(larger trees include middle sections).
This will depend on what model you have purchased. Also included
is a metal base .
Remove all Packaging (i.e. cardboard or plastic) before beginning.
1. Choose a location where the tree is to be displayed. Take out the
tree stand.
Metal stand unfolds as "X" shaped as Figure1, place it on a flat
surface.
2. Insert the pole with tapered end of the tree bottom into the tree
stand and tighten the 3 screws on the stand.
3. Insert the middle tree section into the tree bottom and push down
into position.
(Note: This does not apply to trees with only A+D)
4. Insert the tree top into the middle tree section and push down into
position.
5. CONNECTING THE STRINGS WITH POWER:
Please find the power supply cord on the bottom Section. If there is
no power supply cord, follow the method below: Carefully connect
the plug to end-connector by A to A, and B to B.
6. Gently lower all main branches on tree sections.Take care not to
place unnecessary pressure on the brackets when assembling. The
branches on your tree can be adjusted to give tree the desired
amount of fullness. For best results, straighten and separate all
branch tips, then bend them slightly upward.
06
1
Make the innermost tips
to be 90° to the branch
and between-tips 45
2
Make the next layer tips
to be 60° to the branch
and between-tips 45
3
Make the next layer tips
to be 45° to the branch
and between-tips 45
4
Make the outermost tips
to be 5 direction as
picture,the top one to be
180° to the branch.
7. Plug tree lights into a power outlet.
07
Publicité
