Before carrying out any maintenance,
make sure there is no cookware on the
hob and that the hood and the hob are
disconnected from the power supply.
6.2 Cleaning the grease filter
Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip on
the filter panel underneath the hood (1).
1
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter -
optional
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the two latches counterclockwise by
90 degrees. Slightly tilt the charcoal filter,
then pull it out.
3. To install a filter, perform the same steps
in reverse order.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
67
1
2