Publicité
seconds if the charcoal filter must be
replaced or cleaned.
This function activates independently
after 40 hours of operation for grease
filter and 160 hours of operation for
charcoal filter.
Refer to Cleaning the grease filter in the
Care and cleaning chapter.
Refer to cleaning the charcoal filter or
replacing the charcoal filter in Care and
cleaning chapter.
To reset the function counter in the
notification period, touch the
6. CARE AND CLEANING
6.1 Notes on cleaning
Cleaning Agents
Keep the hood
clean
Charcoal filter
symbol for 3
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains appliance must be
cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior and grease filters
carefully from fat. Fat accumulation or other residue may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may
discolour, it has no influence on the performance of the appliance.
The time of saturation of the charcoal filter varies depending on the type of cooking and
the regularity of cleaning the grease filter. Refer to leaflet included in the accessory.
seconds. The symbol stops blinking for the
correct reset.
The function counter for charcoal filter is
disabled by default. For recirculation
mode, it must be activated.
To activate or deactivate the counter for
charcoal filter:
1. Switch on the control panel.
2. Make sure the fan and the light are turned
off.
3. Touch the
The function is activated if symbols
blink once. The function is deactivated if
symbols
and
66
symbol for 3 seconds.
blink twice.
and
Publicité
