Publicité
Safety Guidelines
Warnings
To uphold compliance with network protection standards, all active cellular devices must maintain at
least 6 feet of separation distance from Panel and Dome antennas.
Use only the power supply provided in this package. Use of a non-Wilson Electronics product may
damage your equipment.
The Signal Amplifi er unit is designed for use in an indoor, temperature-controlled environment
(operating temperature ranges from -40°C to 60°C – -40°F to 140°F). It is not intended for use in attics
or similar locations subject to temperatures in excess of that range.
RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons.
AWS Warning: The Outside Antenna must be installed no higher than 10 meters (31'9") above ground.
This is a CONSUMER device.
BEFORE USE, you MUST meet all requirements set out in CPC-2-1-05.
You MUST operate this device with approved antennas and cables as specifi ed by the manufacturer.
Antennas MUST NOT be installed within 20 cm of any person.
You MUST cease operating this device immediately if requested by ISED or licensed wireless service
provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by
using this device.
This device may operate in a fi xed location only, for in-building use.
FOR MORE INFORMATION ON REQUIREMENTS SET OUT IN ISED CPC-2-1-05,
SEE BELOW:
http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08942.html
12
EN
IN-BUILDING CELL SIGNAL AMPLIFIER
PRO 1100
Publicité
