Publicité
8
OPERATING INSTRUCTIONS
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
8.1
Switching On-off
Press On-off switch I/O (2)
8.2
Attaching the sandpaper
▪
Select sandpaper with the correct grain size. Make sure the perforations in the paper
coincide with those on the sanding base plate.
▪
Then attach the sand paper to the sanding plate, using the hook-and-loop system of the
sand paper and the sanding plate.
▪
The sandpaper should rest flush on the base plate and must not come loose.
▪
You can be sure to find the right sandpaper among our product range (see technical
specifications).
For even a better dust extraction of the working surface, your sanding
machine can be connected to the ordinary vacuum cleaner for house-use
with a dust extraction connector.
9
TECHNICAL DATA
Power rating
Mains voltage
Mains frequency
Sanding surface
No load speed
Safety class
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration):
11
CLEANING AND MAINTENANCE
▪
The machine does not require any special maintenance.
▪
For safe and efficient working, always keep the machine and the ventilation slots clean.
▪
Always be sure that the tool is switched off and unplugged before carrying out any work on
the tool.
Copyright © 2024 VARO
POWC40200
130W
220-240V
50Hz
140 x 140 x 80mm
-1
14.000 min
II
74 dB(A)
85 dB(A)
5.4 m/s²
P a g e
| 5
EN
K = 1.5 m/s²
www.varo.com4
Publicité
