Publicité
Do not use the vacuum cleaner without a dust bag and/or fi lters.
If the opening, which sucks air, hose or telescopic tube are clogged,
you should immediately turn off the vacuum cleaner Before restart
ing the vacuum cleaner, fi rst remove the blocking item.
Do not use the vacuum cleaner too close to heaters, radiators, cig
arett e butt s, etc.
Before using the vacuum cleaner, remove sharp objects from the
fl oor to avoid damaging the dust bag.
Do not collect fi ne parti cles such as: fl our, gypsum, printer toners,
etc., as this may clog fi lters and damage the vacuum cleaner.
Make sure that extension tube is fully withdrawn before you put
away your vacuum cleaner either in verti cal or horizontal positi on.
SPECIFICATION:
Power specifi cati on:
Nominal power:
Maximum power:
Net weight:
YOUR APPLIANCE:
1. Upholstery nozzle
2. Telescopic tube
3. Universal 2in1 brush
4. Dust bag
5. 2in1 crevice and book att achment
6. Hose
7. Fabric dust bag
8. Adjust power
9. On / off butt on
10. Power cord retract butt on
9
2
6
4
Assemble the appliance
Always unplug the appliance before att aching or removing att ach-
ments!
•
Insert the end of the hose into the inlet opening. Push unti l
the end falls into place with an audible click.
Note! Figures are for illustrati ve purposes only Individual models
may vary.
EN
AC 220240V~ 50/60Hz
800W
900W
5,3 kg
8
3
10
1
5
7
•
Remove the hose press butt ons on the hose end, unlatch
and remove the hose from the inlet port.
•
Connect the telescopic tube with the hose and the brush.
•
Extend the telescopic tube to the desired length.
•
Before you start vacuuming, extend power cord cable to suffi
cient length and insert the plug into the wall socket. The yel
low mark on the power cord indicates it is extended almost
all the way. When you see the red mark do not pull the power
cord any further.
•
Use the on/off butt on to turn on the appliance. When you
have fi nished using the appliance, press the on/off butt on to
turn off the vacuum cleaner.
•
Unplug the cord from the wall outlet.
•
Wind up the connecti ng cord by pressing the power cord re
tract butt on. To do this hold the cord to prevent it from tan
gling or bumping the plug on the vacuum cleaner housing.
6
Publicité
