Publicité
9.2
Cutting hedge
Before you start your work, select branches with a diameter not bigger than 22mm and cut them
with a pruning shear. A trapezoidal cut corresponds to the natural, growth of plants and results
in optimal hedge growing.
▪
First cut the sides from the bottom to the top. Cut the upper part giving it the shape you
prefer, in a straight horizontal form, roof-like or rounded.
▪
The safety blade has laterally rounded and staggered cutting teeth to reduce danger of
injury. The additional shock protection avoids inconvenient kickback when the blades
come into contact with walls, fences etc.
▪
Caution! Metal obstacles like fences etc. may damaged the cutting blades.
10 CLEANING AND MAINTENANCE
▪
Check your machine regularly before starting the work.
▪
Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
▪
After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
▪
Always keep the ventilation slots in motor housing clean
▪
Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine. Finally, dry the motor housing carefully.
▪
Store the machine with the supplied protection cover.
▪
Only use original accessories and spare parts.
11 TECHNICAL DATA
Type
Voltage
Blade length
Cutting length
Cutting capacity
No load speed
12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)
Copyright © 2024 VARO
POWDPG7536
POWDPG7536
40V
670 mm
600 mm
24 mm
1200 min-1
77 dB(A)
90 dB(A)
3,0 m/s²
P a g e
| 8
EN
K = 1,5 m/s²
www.varo.com
Publicité
