Publicité
9 CLEANING AND MAINTENANCE
Always ensure that the tool is switched off and the plug is removed from
the power socket before making any adjustments or maintenance
procedures.
Keep the tool's air vents unclogged and clean at all times.
9.1
Replacing the carbon brush (Fig. 13)
▪
During use, the carbon brushes will wear down. This will result in a possible loss of power
and excessive sparking seen through the ventilation slots. When the carbon brushes
have worn down to approximately 4-5 mm, they will require replacing. Carbon brushes
must always be replaced in pairs.
Tool service and maintain must be performed only by qualified repair
personnel.
10 TECHNICAL DETAILS
Model nr.
Rated Voltage
Rated Frequency
Rated Power
Variable speed
Working bar length
Sanding belt size
Cable length
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
Copyright © 2024 VARO
POWX139
POWX139
230-240 V
50 Hz
400 W
300-1700 m/min
80 mm
13x457 mm
3 m
80 dB(A)
91 dB(A)
1,2 m/s²
P a g e
| 6
K = 1,5 m/s²
www.varo.com
EN
Publicité
