Publicité
ENGLISH
4
Switching ON / OFF
Press and hold the power button for >1.5 seconds to turn the unit ON,
the battery indicator LEDs (showing the current level of charge) and
the main light will illuminate.
To put the RX+L in to STANDBY press and release the power button. The
main light will go off but the battery indicator LEDs will remain on. In this
state the RX+L will respond to any signals from registered RX+ products.
Press and release power button to turn the light back ON. It will illumi-
nate at the last used brightness and colour settings.
To turn the RX+L OFF press and hold the power button for >1.5 seconds,
all lights will go out and the unit will not respond to any registered RX+
products.
Controlling the Light
When switched on, the RX+L will illuminate at the colour and brightness
set when it was last illuminated.
The – and + buttons will control the brightness of the RX+L light. The
unit has four brightness settings. Once the maximum brightness has
been reached, subsequent presses of the + button will have no effect.
Equally, once the minimum brightness has been reached, subsequent
presses of the - button will have no effect.
Double tapping the – or + button will change the LED colour from white
to orange or orange to white. The new colour will come on at the same
brightness setting as the previous colour.
Registering RX+ Products to the RX+L
The RX+L has 12 memory locations available for registering other RX+
products and there are two ways to register these with the unit:
(1)
Registering an additional RX+ Product
Press and hold the power button and the + button together, for >1.5
seconds, until the light starts to slowly flash orange.
To register an RX+R, press and release either the - or + button of the
pairs labelled '1', '2' or '3' on the RX+R that you wish the RX+L to be
assigned to.
To register an RX+ Micron or RX+S simply switch ON that unit.
Once an RX+ product has been registered to the next available mem-
ory location, the RX+L will confirm this with one long, white flash, before
returning to flashing orange and waiting for the next RX+ product to
be registered.
When all 12 memory locations have been used, the RX+L will auto-
matically exit the registration mode. This is indicated by flashing white-
orange-white, before the unit goes into STANDBY.
Publicité
