VARO POWERPLUS POWDP6050 Traduction Du Mode D'emploi D'origine page 41

9.9 Vacuuming up liquids
▪
Check whether the new advanced dust filter has been removed.
▪
Mount the sponge filter.
▪
Make sure the inside of the tub (5) is clean and free from dust.
▪
Mount the tube (10) to the hose (8) and fit the wet & dry floor brush.
9.10 Drain function (Fig. 4)
▪
When your tank is full of water, just twist the cover of the drain function to let the water out.
9.11 Blow function
▪
Insert the hose connector into the blowing mouth to use the blowing function.
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, remove the
battery.
10.1 Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Do not submerge the motor housing in water!
10.2 Cleaning the tub
▪
Empty and clean the tub (5) after each use.
▪
Dry the tub carefully after the machine has been used for vacuuming up liquids.
10.3 Cleaning the advanced filter
▪
Shake out the dust from the filter after each use.
▪
Remove mesh and clean it carefully.
Copyright © 2021 VARO
POWDP6050
P a g e | 9
EN
www.varo.com