Publicité
CP 0017 SVR
♦
For the machine to maintain the specified
vibration values, always check the following:
Too large a clearance between the insertion tool s
shank and the chisel bushing will generate
increased vibrations. To avoid getting exposed to
excessive vibrations, check the chisel bushing for
wear every day.
If the machine has a vibration-absorbing
♦
handle/handles, check that it moves freely (up
and down) and does not jam.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Make sure that all the attached and related
♦
equipment, such as hoses, water separators and
oilers are properly maintained.
Periodic maintenance
After each operating period of approximately 100
impact hours or three times a year the machine must
be dismantled and all parts be cleaned and checked.
This work must be performed by authorized staff,
trained for this task.
As a guideline, to maintain a high output the parts
in the table must not be worn more than the
dimensions stated. Note that the CP 0017 SVR does
not have air cushion damping of the piston. This
means that the damping ability cannot be used to
determine the degree of wear on the piston and
cylinder.
Max. inner
Part
diameter mm (in.)
Cylinder
28.63
(1.13)
Piston
-
9800 0621 90c | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Min. outer
diameter mm (in.)
-
28.50
(1.12)
Safety and operating instructions
Assembly instructions
A.
Torque: 65-70 lbf/ft (88-95 Nm), use Loctite®
243™ (Loctite is a registered trademark of
Henkel Corporation. 243 is a trademark of
Henkel Corporation.)
Torque: 11-12 lbf/ft (15-17 Nm), UNF
B.
44 (1-
3
⁄
in.)
4
Torque: 11-12 lbf/ft (15-17 Nm), UNC
C.
x 32 (1-
1
⁄
in.)
4
Torque: 12 lbf/ft (17 Nm), use Loctite® 243™,
D.
M6 x 40 - 12.9
E.
Do not lubricate support rolls, wear ring or
corresponding contact surfaces.
Remove the O-ring from the seal before
F.
assembly. The O-ring is only a support to
ensure that the seal retains the correct shape
until it is fitted.
Troubleshooting
If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
1
⁄
in. x
4
1
⁄
in.
4
17
Publicité
