Publicité
Swith Alarm On / Off
Press Alarm On/Off button to switch on/off the alarm; the corresponding alarm's
icon will be lighted on/off.
Alarm setting (volume and light)
PACKAGING CONTENT
1. Press and hold Volume-Light button for 2 seconds to enter into the alarm
setting; the volume digits flash.
Press +/- button to adjust the alarm buzzer volume.
Buzzer volume : 55dB - 65dB - 75dB - 85dB - 95dB
2. Press Volume-Light button again; the bottom light will flash.
3. Press Volume-Light button again to save and exit alarm setting.
Stop the alarm when it goes off
When the alarm is sounding, press the 4 buttons on the left to stop and reset
the alarm to go off next day.
Alarrm duration : 3 minutes (default mode)
Snooze time setting
1. Press and hold Snooze button for 2 seconds to enter into the snooze-time
setting mode; the digits flash.
Press +/- button to set the current snooze time.
Snooze time : adjustable up to 15 minutes.
2. Press Snooze button again to save and exit snooze-time setting.
Warranty
The products are guaranteed against any failure resulting from a manufacturing defect. This warranty does not cover defects
due to misuse or normal wear and tear. Please keep your invoice carefully stapled to this guide.
PRODUCT USE
Activate snooze when alarm goes off
PRODUCT USE
RGB light setting
LED display setting
Directive 2012 / 19 / EU
Correct disposal of this produt
Electronic waste should not be thrown away with household waste. Please recycle them
to your authorized agency and check the recycling advice with the relevant local authorities.
SRDi declares that the product «Color Alarm Clock» is in conformity with directives 2014/30/EU & 2014/35/EU & 2011/65/EU.
The full EU declaration of conformity is available by scanning the QR Code :
2023/0801/MKG
When the alarm is sounding, press Snooze button, then the alarm will suspend
and go off again after the snooze time set previously.
1. Press Light button to turn on the light.
2. Continue to press the Light button to change colors.
The 7 colors sequence : Warm white, red, green, blue, RGB flowing, RGB
changing, RGB breathing.
3. When the bottom light is ON, press +/- button to adjust the brightness.
4. When the bottom light is ON, press and hold the Light button for 2 seconds
to turn off the light.
Press the Multicolor button to change the color of the LED display.
The 8 colors sequence : White, red, green, blue, RGB changing, Random color,
RGB left to right flowing, RGB top down ward flowing.
SRDi - 85430 La Boissière des Landes FRANCE
SRDi - 85430 La Boissière des Landes FRANCE
Publicité
