Publicité
Hair straightener Use instructions
Slowly slide the straightener down the whole length of the section, from the roots to the tips.
The curved structure of the appliance gives the effect and fixes the curl.
Remove the straightener and use your fingers to twist the section again so that it takes its natural position.
Repeat if necessary.
You may wish to set the curls using a light misting of hairspray.
For more sophisticated curls
Take up a section and place the straightener at the roots with the curved plates facing your scalp.
Turn the straightener 90° upwards so that the curved plates now point outwards.
You can use your other hand to hold the stay-cool tip to make handling the straightener easier and to maintain
an even pressure on the section.
Slowly glide the straightener over the length of the section, from the roots to the tips.
The more even and the slower the stroke, the more marked the curl!
The curved structure of the plate gives the effect and fixes the curl.
Remove the straightener and use your fingers to twist the section again so that it takes its natural position.
Repeat if necessary.
You may wish to set the curls using a light misting of hairspray.
To straighten your hair
Separate your hair into sections. Clip the upper sections to the top of your head so that you can work with the
sections underneath.
Take up a section of about 2/3cm wide and place it between the 2 heating plates, near the roots of your hair.
Press the straightener, hold firmly to keep the section, and slide the unit slowly down the section from roots to
tips. Proceed with another strand in the same way and then with all the others, until the whole hair is completely
straightened.
If necessary, repeat the operation, and release the pressure on the plate.
Style the hair for the final touch. If necessary, fix the straightening with a light mist of hairspray.
To shape your hair
Beper hair straightener can also be used to highlight some strands (fringe, waving the tips inwards or outwards,
etc.) and lift the roots.
To lift the roots, take up a section and hold it vertically from your scalp.
Place the appliance as close as possible to the roots, close the section between the plates and give the applian-
ce a forward rotation to give the maximum volume to the root. Hold for a few seconds, then slowly straight from
the roots to the tips.
To turn the tips of your hair inside, use as described above but directing the appliance inwards (as
with a brush during brushing).
Hold in place for a few seconds and release.
To turn the points outwards, follow the same steps but turn in the other direction.
After use, turn off the straightener by pressing the appropriate ON/OFF button for a couple of seconds. The
appliance turns off and the initials OFF appears on the display.
Unplug the appliance from the electrical outlet.
Allow the appliance to cool off before storing it away.
Cleaning and maintenance of your straightener
Unplug the unit and allow it to cool completely.
Clean the plates using a soft, damp cloth, without detergent, to preserve the optimal quality of the plates.
Do not scratch the plates.
Warning: after use, do not roll the cord around the appliance. Before putting the straightener away,
wrap the cable in large, soft circles.
Technical data
Power: 54W
Power supply: 110-240V - 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
10
Publicité
