Publicité
Installations
1
3
Prepare lamp, accessories and tools well firstly.
1.
Use Allen wrench to loosen the light panel and adjust it to the demanded lighting angle
2.
(see picture ①), then fix the screw tightly (see picture ②).
Rotating the screw to loosen the bracket (see picture ③), adjust it to the appropriate
3.
angle and then fix the screw tightly (see picture ④).
Installation A: Wall Mounted
Please use the measure card to drill 2 holes of Φ8mm with a spacing of 132.5mm, then fix
the lamp onto the wall with expansion plugs and screws.
* The recommended mounting height is 2-4Mtrs.
13 2. 5 m m
Measure Card
Installation B: Put on flat surface directly
Push aside the stand bracket and put it on a flat surface.
2
Installation C: Hang on the wall
① Please drill 2 holes of Φ8mm on the wall with a spacing of 88.5mm. (see picture ①)
4
② Fix the expansion plugs and screws into the holes with a spare space(do not lock to the
bottom). (See picture ②)
③ Push aside the stand bracket, align the hanging holes to the screws and hang the lamp
on the wall. (see picture ③)
* The recommended hanging height is less than 2Mtrs.
1
Installation D: Pole mount (optional)
(Requirements for pole installation: 2 U-brackets) (not
included in the package)
U-bracket
Applications
* It can be used as wall light, flood light, security light, camping light, portable
light, work light, hanging light etc, very flexible and functional!
* You can easily install it in your garden, courtyard, garage, pathway, entrance, villa etc.
Notice
1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends on sunshine duration & weather & work mode.
2
3. The lamp will light up automatically at dusk in Sensor Mode.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is replaceable.If any need,
please contact seller for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new ones, please toward the
solar panel to sunshine or a strong light to activate the lamp.
7. Non-professionals please do not disassemble the lamp.
3
8. Please do not dispo se the battery with household garbage to avoid explosion.
Please use 2 shaped supports
of U to mount the lamp on the
post.
This installation can be used for both
round lighting pole (diameter Φ40~60mm)
and square lighting pole (diameter
Φ30~40mm).
Publicité
