Swing JUST1 Guide D'utilisation Et D'instruction page 6

REMOVING LENS:
•Hold the frame at the bottom and grab the top of the frame from the inside.
Gently pull the top of the frame from the lens, to disengage the lens notches
from the frame posts.
•Once the top of the lens is separated from the frame, gently pull the lens out of
the sides and the bottom of the frame.
INSERTING LENS:
•Start by inserting the lens at the nose, align the notches on the lens with the
posts of the frame, make sure the lens is lined up with the groove of the frame.
Once lined up, push the lens onto the posts.
•insert the lens on each side of the frame. Make sure that the lens is pushed
completely into the groove of the frame.
•At the top of the frame, align the notches on the lens with the posts on the
frame. Make sure the lens is lined up with groove of the frame. Once it is lined
up, push the lens onto the posts.
•Check the lens to make sure that it is correctly and fully inserted into the lens
slot and that all lens notches are properly engaged with the appropriate frame
posts.
•Peel the protective backing from the inside of the lens.
REPLACEMENT OF THE ELASTIC STRAP:
- Unscrew both the rivets on the sides of goggles (fig. 1).
- Remove the strap inserted in the slot on the frame (fig. 2).
fig. 1 fig. 2
6