Publicité
SIDE MOUNTING
1. Attach crossbar to junction box. Set the crossbar so
the longer blade is touching the junction box.
(See Figure 3)
Figure 3
Plastic
Housing
EXIT Panel
Directional Arrow
2. Open the EXIT housing.
(See Figure 4) Feed the
transformer input leads
through side hole and
secure wire into wire guides
molded at the edges of the
sign. (See Figure 3)
3. Attach sign to canopy by inserting canopy into sign
at an angle, then twisting to secure. (See Figure 3)
4. Make the proper supply lead connections. If using
120VAC, connect the black and white leads to the
building utility. If using 347VAC, connect the red and
white leads to the building utility. Cap off unused
wire. If the unit is self-powered, ensure battery
connector snaps together.
5. Feed excess wire into junction box and align holes in
canopy with holes in crossbar. Use screws supplied
to tighten canopy to crossbar so canopy is securely
fastened and tight against wall. (See Figure 3)
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first then bottom.
CAUTION! Battery connector is shipped
disconnected. Snap connector into
socket at installation. (See Figure 7)
Use manual battery test switch on base of unit
to test. Red LED indicates normal operation.
(See Figure 8)
PAGE 2 OF 6
INSTALLATION CONTINUED
Back Plate
Canopy
Wire Nuts
Diffuser
Cross bar
Crossbar Screws
Snap-in
(not included)
Figure 4
CEILING MOUNTING
1. Attach crossbar to
junction box. Set
the crossbar so
the longer blade
is touching the
junction box.
(See Figure 5)
2. Open the EXIT
Junction
Box
housing.
(See Figure 4) Feed
the transformer
input leads through
top hole and
secure wire into
wire guides molded
at the edges of the
sign.
3. Attach sign to
canopy by inserting
canopy into sign at
an angle. Twist to
secure. (See Figure 6)
4. Make the proper
supply lead
connections. If
using 120VAC,
connect the black
and white leads to the building utility. If using
347VAC, connect the red and white leads to the
building utility. Cap off unused wire. If the unit is self-
powered, ensure battery connector snaps together.
5. Feed excess wire into junction box and align holes in
canopy to crossbar so canopy is securely fastened
and tight against the ceiling.
6. Snap in arrows to EXIT panel as required. Then snap
EXIT panel to housing: top first, then bottom.
BATTERY
Battery
Battery
Connector
Socket
π
1 800 295-5510
uline.ca
Figure 5
Junction
Cross bar
Canopy
Plastic
Housing
EXIT Panel
Figure 6
Figure 7
Red LED
Box
Diffuser
Snap-in
Directional Arrow
Canopy
Figure 8
Manual Battery
Test Switch
0624 IH-6508
Publicité
