Publicité
4. MAINTENANCE AND REPAIR
Maintenance and repair must be carried out by qualified personnel authorized by the manufacturer.
The manufacturer declines any responsibility for jobs carried out by unauthorized
personnel or the use of non-original spare parts.
4.1 ROUTINE MAINTENANCE
Prohibited to remove the guards and safety devices: It's strictly forbidden to remove
guards or safety devices when performing routine maintenance operation. The manufacturer
disclaims all liability that may arise this regulation is not observed.
In case of FIRE:
- Disconnect the unit from the electrical power socket.
- Do not use water to extinguish the fire.
- Use powder or foam extinguishers.
4.1.1 Cleaning the interior and exterior of the appliance
The appliance is designed for the products storage so it is important to keep it clean. The
equipment is thoroughly cleaned at the factory before being shipped. We recommend, however, to
clean the interior cabinet before the first start up of the appliance. Before attempt any cleaning
operation make sure the power cord is disconnected.
-Cleaning product: use soft clean cloth wet with water and neutral detergent only.Do not use
solvent or bleach.
-Rinsing: use a cloth or sponge soaked with fresh clean water. Do not use water jet.
-Frequency: once a week or at different intervals in accordance with the type of product.
4.1.2 Sliding door's rails
Keep clean the sliding door housing to avoid the door can't close completely. Use a soft clean cloth
or a soft brush in order to remove any residuals can block the door to slide in the full closure
position.
4.1.3 Condenser cleaning
The condenser is a heat exchanger. If it is dirty or clogged the air cannot circulate freely through
the same, it cannot discharge heat properly so reducing proportionally the performance and the
efficiency of the refrigeration system.
FOR THOSE REASONS IT IS IMPORTANT TO KEEP CLEAN THE CONDENSER COIL,
TYPICALLY MONTHLY.
cleaning.
Use and Operational Manual
30
Publicité
