Atlantic F18 Notice D'utilisation Et D'installation page 9

3) Adjusting the Eco temperature :
This is the required temperature during periods when the room is unoccupied.
It is recommended that this mode should be used if the room is unoccupied for more than 2 hours.
a) Set the cursor to , the light V2 comes on.
b) Adjust thumb-wheel
the desired Eco temperature setpoint.
c) Wait for a few hours until the temperature stabilizes.
d) If you are happy with the setting (use a thermometer to check if you wish) mark the position once and for all.
Otherwise, modify the setting and return to item c).
4) Frost free : HG ❄
This mode keeps the temperature at about 7°C in the room when the house is unoccupied for a long period (usually more than
24 hours).
to ❄
a) Set the cursor
5) The heating light :V1
This light indicates periods during which the resistance is heating.
6) Switching off the device
To set the device to the Off position, move the cursor to
7) Locking the controls
It is possible to lock or limit the range of use of thumb-wheels
tor switch cursor to prevent the inadvertent manipulation of the device (by children,
etc).
a) Detach the device from its wall bracket.
b) On the back of the thermostat box, detach pins P from their supports.
c) Choose position B to lock the thumb-wheels or position L to limit the range of use
of the thumb-wheels.
Choose one of the positions M to lock the person in the desired mode.
8) Programming mode
This device has a thermostat capable of receiving orders through its pilot wire.
It recognizes the following commands:
- CONFORT (comfort)
- CONFORT –1 (comfort –1) : Temperature set using the thumb-wheel
- CONFORT -2 (comfort –2) : Temperature set using the thumb-wheel
- ECO
- HORS GEL (frost-free)
- ARRET (Off)
To activate the programming mode set cursor
In this way, by connecting the pilot wire to a timer, you can program your Comfort and Economy temperature periods. It is pos-
sible to connect several devices to one timer and, in this way, make energy savings.
NB: When there is no command given over the pilot wire, the device heats in the Comfort mode. HG and load-shedding com-
mands override the Economy and Comfort modes. On changing from the Comfort mode to the Economy mode, the changeover
time is approximately 12 seconds.
- There is no point in setting the unit to its maximum, the room temperature will not rise any faster.
- Switch the unit off by putting cursor
- Remember to lower the temperature if you go out for several hours.
If go out for : less than 2 hours, do not touch the controls.
- If you have several units in the room, let them all operate at the same time, this will give a more uniform temperature without
increasing electricity consumption.
to between 3 and 4 so that the heating indicator light V1 comes on if the room temperature is below
: Temperature set using the thumb-wheel
: Temperature set using the thumb-wheel
: Room temperature maintained at approximately 7°C
: Immediate stoppage of the device (used for load-shedding).
to
III - R
ECOMMENCATIONS FOR USE
to
from 2 hours to 24 hours, set the cursor
for more than 2 hours or during the summer, put the unit in Frost Free mode.
to and lock selec-
: -1°C
: -2°C
.
to