Atlantic F18 Notice D'utilisation Et D'installation page 7

The product you have just purchased has undergone numerous tests and inspections to guarantee the highest quality.Thank you for your choi-
ce and your confidence in us.We hope it will give you entire satisfaction.
Some recommendations :
Please read the documentation before starting to install the panel heater.
Disconnect power before working on the panel heater.
Conserve the documentation, even after installation of the panel heater.
Equipment specification (indicated on the label of the device):
CAT B or C : device satisfying the requirements of the NF Electricité Performance
(French electricity performance standards) for the given category criteria.
IP24 : Equipped protected from water splashes
Class II : Double insulation.
I - W
1) Where to install the panel heater
- This equipment was designed to be installed in a residence.
Please ask your distributor before using it for any other purpose.
- The panel heater should be installed according to normal trade
practice and in compliance with legislation in the relevant country
(the IEE Wiring Regulations).
- Comply with the minimum clearance distances as indicated in
diagram 2 for positioning of the panel heater.
- If your wall covering is laid on foam, a spacer the same thick-
ness as the foam must be placed under the panel heater's support.
This ensures there is free space behind the panel heater to make
sure its control settings are not adversely affected.
Do not install the panel heater:
In a draught likely to affect the control settings
(under a fan, etc.).
Under a fixed mains power socket.
In volume 1 of bathrooms.
In volume 2 if the controls can be operated
by a person using the shower or the bath.
It is strongly recomended not to install vertical products we manufacture above an altitude of 1000 metres.
If the device is installed at altitude the air discharge temperature will be increased
(by approximately 10°C per 1000 m of altitude).
It is forbiden ti install vertical product in horizontal position.
2) How to install the panel heater ?
2-1) Mount the wall support
Model Standard/Hight
3
HERE TO INSTALL THE PANEL HEATER