Publicité
OPERATING
INSTRUCTIONS
1. Read safety instructions
2. Connect the charger to the battery.
3. Connect the charger to the wall socket. The power lamp
will indicate that the mains cable is connected to the wall
socket. The error lamp will indicate if the battery clamps are
incorrectly connected. The reverse polarity protection will
ensure that the battery or charger will not be damaged.
4. Press the MODE-button to select charging program.
Follow the display through the charging process.
The battery is ready to start the engine when "GO" is lit.
The battery is fully charged when "CARE" is lit.
5. Stop charging at any time by disconnecting the mains cable
from the wall socket.
Battery ready to
crank once
MODE
More than X hours
of charge time left
TRY
>8
4
ERROR
MODE
LAMP
BUTTON
POWER
NORMAL
LAMP
BATTERY
PROGRAM
Battery ready
to use
GO
CARE
2
1
HOURS
AGM
RECOND
PROGRAM
PROGRAM
Fully charged/
maintenance charge
EN • 9
Publicité
