Publicité
Unplug the unit and remove the drain plug from the inside of the freezer.
Defrosting usually takes a few hours. To speed up the process, leave the freezer
door open.
For draining, place a tray beneath the outer drain plug and pull out the drain dial
Rotate the drain dial 180
push the drain dial in. Insert the drain plug inside the freezer compartment.
Note: monitor the container under the drain to avoid overflowing
Wipe the interior of the freezer and replace the electrical plug in the mains outlet
Reset the temperature control to the desired setting.
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician person must
perform any troubleshooting not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes too much
The food is not frozen enough
Unusual noises
Heavy build-up of frost on the
door seal
If the malfunction shows again, contact the Service Centre.
o
and let the water flow out in the tray. When finished,
Possible Cause
Mains plug is not pugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is set to cold or the
appliance runs at "7" setting.
Temperature is not properly
adjusted
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Door seal is not air-tight
Solution
Plug into mains socket outlet
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulation
knob to a warmer setting
temporarily.
Please refer to the Temperature
setting section of the manual
Open the door only if necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same time, shape the
warmed door seal by hand so
that is sits correctly.
~ 9 ~
Publicité
