Thetford Aqua-Magic IV Mode D'emploi

Figure 1
Water Valve
Figure 2
Float As-
sembly
Instructions
Removal
1. Shut off water supply from toilet and disconnect water line from its rear. Re-
move nuts at base of toilet. Lift toilet off the flange. Turn upside down.
2. Remove old flange seal from toilet or floor flange.
3. Remove Seat and Cover by gently pulling backward at 45° until they
disengage from toilet. Turn toilet upside down, with back facing you, on a
padded work surface. Remove Mechanism Cover and Water Valve: loosen
screw behind and to right of Water Valve. Loosen four housing screws
located in 3, 7, 9 and 11 o'clock positions (Fig. 1). Remove two Water
Valve anchoring screws. Turn toilet upright.
4. Grasp Mechanism Cover by hinge opening and gently lift and tilt off, ex-
posing lever spring, link and water valve. Restrain left end of lever spring
while disengaging right end carefully from spring notch and set aside.
Disconnect link from water lever and from water valve arm hole with a
twisting action. Remove Water Valve and Float Assembly.
Link
Screw Locations
Figure 3
Seal, Ball
Valve to Bowl
Parts/Pièces/Particulos
RV Toilets/cabinets permanents/inodoros fijos
Aqua-Magic
Water Valve Replacement
Remplacement du robinet de prise
Made in U.S.A./Fabriqué aux É.-U./Hecho en EE.UU.
Thetford Corporation
1-800-521-3032
Ann Arbor, MI 48106 •
Water
Lever
Link
Flush Lever
Installation
1. Place Float Assembly in upright position before installing water valve
(Fig. 2).
2. Place O-ring on water valve neck Turn toilet upside down. Install water
valve with two anchoring screws.
3. Turn toilet upright. Re-engage link and lever spring into locked positions.
Set Mechanism Cover in place and turn toilet upside down.
4. Install four mechanism screws in place. Turn toilet upright. Reattach Seat
and Cover. Apply new flange seal. Remount to floor. Connect water line.
13168
Part No.
No de pièce
particulo No.
IV
®
d'eau
• www.thetford.com
Figure 4
Link