Publicité
Appendix
How to Use an External Device Using the Remote Control
When setting other manufacturer s product using the remote control, some of the buttons on the remote control may
not operate or different functions may be activated, or some of other manufacturer s products may not work. Some
of DVD/VCR combos are allowed only either in DVD mode or VCR mode.
VCR Setting Number Table
59
All manuals and user guides at all-guides.com
1. Turn on the external device you want to set.
2. Whenever you press
VCR
DVD
SAT(Satellite Receiver)
Or Press the
button and the prefered device(TV/VCR/DVD/SAT) at once.
3. If the external device has been chosen, press the
at the same time for two seconds.
4. Enter an appropriate 3-digit number of the manufacturer from the DVD Setting
Number Table. (If the product brand you want to set has multiple setting numbers,
attempt to enter the setting numbers repeatedly until the product is turned off.)
5. When the product has turned off, press the
(The appropriate button associated with the product will flash 3 times to show the
product operates properly.)
6. Check that the Power button works normally and then check that other function
buttons work normally.
If the Power button works normally but other function buttons do not, repeat the
above steps from the beginning.
Depending on product brands or setting numbers, the power button may work
normally but other function buttons do not work.
button on the remote control, the mode shifts
in order.
button again.
TV
button and
button
Publicité
