Publicité
STEP ONE :
Should the LED lights not be working in the rail - Firstly , make sure the wall outlet cord is plugged in to a live A/C
outlet properly. Secondly , make sure the A/C Adapter (A4) is tightly plugged in to its outlet under the table .
Lastly, make sure all LED Rail light connections are snuggly plugged into the Main Electronic Unit (C3) . At this point ,
should the LED Rail Lights still not be working , please disconnect the A/C power to the table before proceeding .
A call will be required to our Customer Service Department
to acquire the necessary replacement part(s) .
STEP TWO :
If the LED Light Strip needed to be replaced on
the P1 Cabinet inner side, take the C1/C2 LED Light
Strip out of the table.
STEP THREE :
Install the replace LED Strip C1/ C2 back to the Cabinet Side Rail.
Align the male and female connectors of the well Lighting LED Strip.
Connect the plug of C1 Lighting LED Strip A , C2 Lighting LED Strip B with C3 ON/OFF Switch Wire.
Next, connect the A4 AC/ DC Adapter with C3 ON/OFF Switch Wire.
C3
C3
C2
All Rights Reserved.
© 202 0 Escalad e Sports
Replacement of LED Light Strip
A4
C1
C2
Fo r Custome r Servic e Cal l 1-888-996-2729
9
C1/C2
C1
C2
Publicité
